MAV-2W High Power Stage monitor

 

Download datasheet               User manual              

 

Frequency Response (1)
Operating Frequency Range (2)
Maximum SPL (3)
Coverage Angle (H x V) (4)


Crossover
Transducers LF-MF
HF


Balanced Input Section Sensitivity
Connectors
Input Impedance
Amplifiers Type
Burst capability (5)
THD, DIM, SMPTE
Protections



DSP on board





Mains AC Power
Current Requirement
Connector
Dimensions (HxWxD)
Weight
Front Protection
Cabinet



Finish
 

50Hz - 18,5KHz
47Hz - 19KHz
137dB SPL
75° x 55°, Range 950Hz - 13KHz


860Hz nominal
15-in optimally vented cone driver.
1,4-in exit, 3-in diaphragm driver, CD horn loading


+4dBu
Female XLR, male XLR loop out
12KOhm balanced
High Efficiency Digital Amplifier
2 x 1200W
< 0,05%
Over-temperature power limiting, Thermal shutdown, Short-circuit, Overload output protection, Soft Clip limiter


48KHz AD/DA, 24bit
Signal routing, Crossovers, System-Eq, Offset delay,
Time-shaped limiters
Full Range / HP (90Hz LR24) switch


Nominal 230VAC(195-240)(6) - 50Hz
4A
PowerCon AC-input connector, link PowerCon Out
435 x 740 x 310mm
25,3 Kg
Powder coated metal grill, open cell foam
18mm baltic birch multiply, marine environment
1 recessed metal handle


Black scratch resistant waterborne coating system

 

Notes
(1) Frequency Response (± 3dB) measured on-axis in half-space loading condition, 1/36 octave frequency resolution. Half space condition occurs when floor, rear or side walls are close to loudspeaker, and affect low frequencies loading.
(2) Range limits stated at - 6dB.
(3) Maximum Full Range SPL measured in half-space loading condition, referred to 1m measurement distance,
with pink noise (6dB crest factor).
(4) - 6dB points.
(5) Amplifier capability with pink noise (6dB crest factor).
(6) Performance Data measured with 230VAC.

MB audiosystems operates a policy of continouos improvement. MB audiosystems reserves the right to alter specifications without further notice. The introduction of new materials or production methods will always equal or exceed the published specifications. Rights for names and trademarks quoted in this document belong to respective owners.